Test fitting the tubes into the end cap. Note the stainless bolts and how they exit the cap for ease in making our electrical connections. To prevent a major mess, I didn't follow the instructions which tell you to put masking tape or electrical tape over the holes to stop the JB Weld from dripping out. Instead I did not drill the larger hole all the way through the cap leaving about 1/16 inch to stop the JB weld from dripping out everywhere. Later when the JB Weld has hardened holding the electrodes securely in place I will invert this and then fill the holes with JB Weld. This will keep things from getting too messy and give a better seal at this location around the threads of the stainless bolts. More on this later.

Previous Picture

Next Picture